✅ Fibaro HC3/HC3L

✅ Standalone 


This guide assumes that you have already setup your CoolMaster/Link/Hub on the network, and registered each unit with the iocControl app (or web based control app). 


If you do not have this app setup, please contact your CoolMaster installer, or in some cases you can set this up yourself by scanning the QR code on the back of the CoolMaster unit.



Step 1 - Click the Add button under the CoolAutomation logo to begin.


Step 2- Enter your username/email address and password, the same as you use with the iocControl app, and click next.


Step 3- Your credentials will be verified, and if successfull, will be advised before continuing.


Step 4 - All available AC units will be discovered, and shown like below, along with confirmation of the new device being added.


Step 5 - This completes the setup of the plugin, and you will be now taken to the Settings page.

From here you can perform a Sync to pickup any name changes or addition/removal of AC units.


If you are uisng Fibaro HC3, you will see an additional device has been created for the Current Temperature, as the native Fibaro HVAC device does not contain this value.\


Now, you will find the new devices have been added, if you are running in Standalone mode, this new device will be on the home page, ready for use with Voice control.


If you are using Fibaro HC3, new devices will be created for each HVAC unit.


Please Note : The plugin updates every 60 seconds from the Cool Automation cloud platform.