First of all connect the automationbridge to your home network. Then connect the power supply, and press the power button on the front of the unit.


The automationbridge will then automatically start up, please wait for 2-3 minutes for this to happen, then using a web-browser go to https://mybridge.skaro.com.au


You will then be prompted to register your device, this will then send you a verification email to complete the setup process, click the link in the email to finalise the setup and then you will be directed to the home page of the automationbridge.


Step 1 - Select the Ness/Elk M1.


Step 2 - Next select the required Voice services, and other options as required, then complete to reboot the automationbridge.


Step 3 - Upon restart, log into the automationbridge, and you will be prompted to setup and configure the M1.


Step 4 - Enter the IP address of the M1 controller (please note that the Secure/SSL Port is NOT supported by this product), and then select your required voice services, click Next to proceed.


Step 5 -The connection to the M1 will be established, once confirmed, click Next to proceed.


Step 6 - The automationbridge will now connect to the M1 and retrieve the available devices, zones, tasks etc. This may take up to 5 minutes to complete.