✅ Fibaro HC3/HC3L (v5.100 or greater)
✅ Fibaro HC2/HCL
* Before you being this process, please ensure that you have setup the Switchbot Hub Mini and any other connected Switchbot devices to your home network. You must also ensure that the Cloud Services are enabled for each device you wish to use.
* Please note only the following devices are currently supported, further devices will be added in the future.
- S1 Bot
- Temp/Humidity Sensor
This guide assumes that you have already purchased the Switchbot plugin from within the automationbridge interface.
Step 1 - Click the Add button under the Switchbot logo to begin.
Step 2 - Follow the on-screen instructions to obtain your developer token, this is required in order to communicate with the Switchbot cloud and your devices, then click the Next button.
Step 3 - The automationbridge will then connect to the Switchbot cloud and verify your token, and if valid, return back the list of available devices, along with showing which ones are supported, click Next to proceed.
Step 4 - The supported devices will then be added to your Fibaro controller, as either Virtual Devices (HC2/HCL) or QuickApps (HC3/HC3L). Not that if you are using HC2/HCL then extra global variables will be created to hold the state and values, which can then be used in Scenes. Click OK to finish the process.
Step 5 - You will then be taken to the Settings page for the plugin, from here you can perform a Sync, which will pickup any new devices in the Switchbot platform, and add them to your Fibaro controller.
If you are using the Fibaro HC2/HCL you will now have your devices added.
If you are using the Fibaro HC3/HC3L controller, you will find your devices added as QuickApps 
You will now be able to enable these devices for your chosen voice control platform (HomeKit/Alexa/Google).