To link the automationbridge to your iOS Home app, make sure that you have enabled some devices via the automationbridge home page,
Make sure to click the button to apply the changes, then just follow the steps below.
When you are ready to add this to your iOS Home app, click the tab along the top of the page, labelled iOS HomeKit.
Here you will find the QR code and homekit code to add the bridge to your iOS Home app.
Refresh Names – forces the bridge to update its names, should these be changed in Fibaro (note this does happen automatically every 10 minutes).
Show Logs – This will show the commands that have been received by the bridge and sent on to your Fibaro system.
Reset – This will reset the Homekit backend, disabling all devices, and generating a new code. If this is done, you will need to remove the old AutoBridgeXXXX from your Home app and re-add it using the new code.
Open the app on your phone/ipad and from the Home page on the app, press the + button at the top right,
Choose Add Accessory,
You can hold the camera on your device up to the screen and the code will scan (you will get a warning that this is an Uncertified Accessory, just press Add Anyway to continue)
Continue thru the setup process by pressing the Next button, at the top right, assigning devices to rooms as required.
Once this is complete, you will find your enabled devices on the Home app, and these can now be controlled by the App & Siri.
For access to the Home remotely, we recommend the use of an Apple TV as the Home Hub, as we have seen issues with using HomePod's